DIY, slideshow

ROG Ginger V1.0 – DIY

Posted on by TH custom effects
19
Apr
[wpdm_file id=53]ginger_diy2

This is my PCB for runoffgroove’s Ginger bass amp emulation.

Here is the link to ROGs project and their soundfiles.

The Ginger is modelled after an Ampgeg SB-12 Portaflex bass amp.

Board mounted pots can be used to make the build easier.

PCBs based on runoffgroove circuits purchased from TH custom effects are intended for DIY / non-commercial use only. Any commercial use whatsoever is forbidden

Overdrive etc.

ROG Ginger V1.0 PCB

$ 8.88

One thought on “ROG Ginger V1.0 – DIY”

  1. otu says:

    Real good kit. Only problem was that the 4 pots aren’t symmetrical (the lay out). The tone pot holes on the pedal box must be wider than the vol pots.

Comments are closed.