Pedal Controller – TH custom effects

Flexible Pedal Control Unit:

Build your own Pedalboard Controller !

processor controlled
easy-to-read display
32 banks of 4 patches each
8 Loops with optional Bi-Amping
Input board with linear driver and Tuner-Out
Allows to build a reduced-parts-version:
- 4 Loops instead of 8
- without linear driver
- without Tuner-Out
- 10 instead of 32 banks

This is a huge project with so many possibilities for you!

Upcomming (still some weeks to go):

12/16 Loops extension board
MIDI interface (either activate stored presets or control loops directly via MIDI program change commands)

Watch our video to find more about it:

Fabbed boards fitting & functional test

3D rendered images of all the boards:

Controller & Display unit

Tuner-Out and Line Driver

Switching Boards

Fits in a small case of 19×12 cm:

Finally: the frontplate is done.

Update on the progress of V2.1 and V3.0:

Revision 2.1:

Manual mode to be able to switch the effect loops directly – in addition to just retrieving the stored presets.
16 loop extension board to control up to 16 loops in total

Revision 3.0:

All of 2.0 and 2.1 and

Up to 16 switches to control the unit. (Not sure yet how they will be used. Using 8 instead of 4 switches for the manual mode seem to be one idea)
MIDI interface to control the unit
– control the PCV3.0 from another device (Like the Line6 HD 500) to activate presets or control single loops
– use SysEx to save and restore/migrate the programmed configurations
– send Program Change messages to control other devices

The V2.1 Prototype including 16 loop extension board:

The V3.0 prototype including 16 switches and 16 loop extension board:

The MIDI extension board:

Here is the 16 Loop prototype enclosure ready to be drilled:

Here is the full PCB set for V 3.0: